|
Protective Coatings
: Disclaimer
GO BACK
Protective
Coatings, such as clear lacquer, were originally intended to give shelf
life to the fittings. Modern improved lacquers give protection for some
time during use, but are subject to deterioration and discoloration
depending on the atmosphere to which fittings are exposed. As opposed to
commonly used "Air-drying" lacquer, we use the best available baked-enamel
lacquering process. However, sea/air pollution, perfumes, soaps and a damp
atmosphere may affect any lacquer. The Finish on outdoor fittings will
last much less than that on indoor fittings.
Discoloration and deterioration in finish should be viewed not as a
defect, but rather a normal and unavoidable process. Lacquer coatings
cannot, therefore, be guaranteed nor claims accepted in this regard.
Damage caused to metal finishes by acids whilst cleaning brickwork etc or
by paints, solvents and chemicals while painting doors etc. can be readily
identified as such we cannot warrant claims where this has occurred.
Please ensure that fittings are adequately protected during construction.
It is recommended that door fittings be removed prior to the application
of paint, varnish or other forms of protective coatings to doors and
surrounding areas.
Protective Coatings : Maintenance
The life of
lacquer may be greatly extended by regular application of a premium
quality wax polish such as "Mr. Sheen" ™. We strongly recommend such
sensible maintenance. Should an item require re-lacquering, all traces of
old lacquer must be first removed with acetone or lacquer thinners, and
items re-polished and re-lacquered with clear lacquers such as "Wattyl
Incralac"™. Avoid use of caustic strippers which
may corrode brass.
Plated Finishes
A selected
range of products is available in plated finishes such as Antique Bronze,
Bright Chrome and Satin Chrome. For larger requirements, we can offer
fittings in other finishes including powder coated colours. When selecting
a finish, it is important that climatic conditions and usage be taken into
consideration as some finishes are susceptible to deterioration as a
result of exposure to corrosive vapours, coastal air, humidity, salt
spray, steam, pollution etc. For these reasons, plated finishes cannot
be guaranteed nor replaced.
Warranty
We provide a
5-year warranty against mechanical defects for our entire range of
fittings used for domestic applications. For the reasons mentioned above,
this warranty obviously cannot be extended to lacquering and finishes.
Specifications
We seek to
improve continuously, we reserve the right to make product modifications.
Please check on current product design and specifications prior to
purchase.
Dimensions
All
measurements indicate maximum dimensions. Unless otherwise mentioned, all
dimensions are shown in millimetres. As items are hand-finished, sizes may
vary slightly.
Installation
The letter box plates can be installed directly into
your course of block or brick work at the time of installation. This is
usually done by your bricklayer who will grout in the plates and use a
piece of FC sheeting to lay across the top (Lintel) and then
continue laying his blocks or bricks over this.
It however is common practice these days to have a
sleeve fitted to these plates. These are usually made from a galvanized
steel. We can supply all brass plates with your nominated sleeve size.
When ordering and you a require a sleeve, please go
to "Sleeves" and pick the suitable item for your shopping cart. You will have an
option there to pick a sleeve with a standard cast aluminum back plate, or
if you have selected a brass back plate to then just select a sleeve only.
All units will be sent out fully assembled. If you need help please call
our toll free number.
|
Shopping Cart
